Now our stunning marquise citrine gemstone ring has been completed! Then form a cross in front of the bead and wrap the wire again at the bottom of the base (picture 9). Secure the top of the bead by wrapping 28 gauge wire 2-3 times against the base on both sides. Tweak the diamond to make sure its width and length can accommodate the bead we use. Then create a symmetrical triangle in the bottom of the ring using the right side wire. Using a chain nose plier, create a triangle in the top of the ring using the left side wire. You should get the shape as shown in picture 5. ![]() Make the base for marquise gemstoneĪfter weaving, bend the other end of the wire downward. Then continue weaving till there is about 1.5cm left. This bend is where to start the weaving process. Then bend one end of the wire upwards using a chain nose plier. Wrap a piece of 22 gauge wire around the ring mandrel. The bead I am using is about 8mm in width, as a result, the length it needs on the ring is about 1.5cm. However, we’ll need to measure the width of the marquise gemstone in advance to make sure there’s enough room left on the ring. Unlike the previous two projects which start with making the base, this project leaves the base to the end.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |